16 se c t i O n 6— Ma i n t e n a n c e & ad j u s t M e n t s
Engine Care
A list of key engine maintenance jobs required for good
performance by the mower is given below. Follow the
accompanying engine manual for a detailed list and instructions.
Maintain oil level as instructed in engine manual.
Service air cleaner every 25 hours under normal conditions.
Clean every few hours under extremely dusty conditions.
that the air cleaner should be serviced. To service the air
cleaner, refer to the engine manual.
Clean spark plug and reset the gap once a season. Spark
plug replacement is recommended at the start of each
mowing season. Check engine manual for correct plug
type and gap specifications.
Clean engine regularly with a cloth or brush. Keep the
top of the engine clean to permit proper air circulation.
Remove all grass, dirt, and combustible debris from muffler
area.
Deck Wash (If Equipped)
surface as part of its deck wash system.
underside and prevent the buildup of corrosive chemicals.
enough for your garden hose to reach.
chute is directed AWAY from your house, garage,
parked cars, etc.
2.
3.
Turn the water on.
5.
Run the engine for a minimum of two minutes, allowing the
underside of the cutting deck to thoroughly rinse.
Release blade control to stop the engine and blade.7.
Turn the water off and detach the hose coupler from the water 8.
After cleaning your deck, restart the mower. Keep the engine
and blade running for a minimum of two minutes, allowing the
underside of the cutting deck to thoroughly dry.
To Next Page
Loading...
Need help?
General
