IMPORTANT: READ OPERATOR’S MANUAL THOROUGHLY AND FOLLOW THE SAFE OPERATION PRACTICES WHILE OPERATING THE UNIT.
Removing Unit From Carton
Assemble The Unit
Starting The Unit
Insert the upper blower
tube into the blower outlet
and turn it clockwise until it
locks into place.
Install the lower blower tube
onto the upper blower tube
and turn it clockwise until it
locks into place.
Assemble The Unit
Place unit on a level surface.
Fill fuel tank.
Press primer bulb 10 times,
or until fuel is visible
Move choke lever to
Position 1.
DO NOT squeeze throttle
control.
Pull rope 5 times. Move choke lever to
Position 2 .
Pull rope 3-5 times to start
engine. Squeeze throttle
control and allow unit to
warm up for 30-60 seconds.
Continue to squeeze
throttle. Move choke lever
to Position 3.
Continue to squeeze
throttle. Warm unit for an
additional 60 seconds to
complete warm-up. Unit
may be used during this
time.
11 2
Remove all contents from
the carton.
5
6
7
19 10
3
Place the unit on a level
surface, remove the oil plug
from the crankcase, and pour
the entire bottle of oil into the
fill hole.
Crouch in starting position.
8
4
Starting The Unit
11
12
13
14
10 X
5 X
3-5 X
Starter Rope
Blower Outlet
Throttle Control
On/Off Switch
DIDN’T START?
Repeat the starting instructions.
IF engine fails to start after 2 attempts,
move choke lever to position 3 and pull
the starter rope until engine starts
IF unit still fails to start, refer to operator’s
manual for additional starting and
troubleshooting information
Primer
Bulb
Primer Bulb
Oil Plug
Tools Required:
• Flathead Screwdriver
Upper Blower Tube
Lower Blower Tube
TB4HB EC
4-Cycle Electric Start Capable Handheld Blower
Operator’s Manual
769-07792 P00 05/12
NEED HELP? Call 1-800-828-5500 in U.S. or 1–800–668–1238 in Canada
ENGLISH — PAGE 1
ESPAÑOL — PAGE 9
To Next Page
General
