LCD 2 Window Displays
Software Installation Instructions for the
Bike 2 Window LCD Displays
First check and record the current software version by pressing and
holding the CLEAR ENTRY button while pedaling. When the screen
blanks out press and hold ENTER until enter code appears, Press
20173 then press ENTER and then START to display the software
version.
Insert the USB Storage Device into the console.
Press and hold Clear/Entry while pedaling until screen blanks out.
Immediately press and hold the channel up/FWD button until code
update appears on screen.
Press Enter and the software will upload to the console
When screen returns to normal mode remove the USB Storage
Device from the console and verify the new software uploaded in the
unit.
To Next Page
Loading...
Need help?
General
