MODEL SERIES
TEC_TM_181 | REV. A | EN 03/23/2023 Page 11 of 32
truemfg.com
Installation & Setup (cont.)
Procedure
1. Remove the outer packaging (cardboard and bubble or
Styrofoam corner and clear plastic). See fig. 1.
NOTICE ›
DO NOT remove the shipping bracket (glass
swing doors; fig. 2) until the appliance is installed in its final
location. DO NOT DISCARD. Use the bracket when next
moving the appliance.
2. With an adjustable wrench, remove all shipping bolts securing
the wood skid to the bottom of the appliance. See fig. 3.
NOTICE ›
Move the appliance as close as possible to the
final location before removing the wooden skid. Your model
may require removing the front and/or rear grill/cover to access
the shipping bolts.
3. Remove the appliance from the wood skid and set the skid
aside.
NOTICE ›
DO NOT lift the appliance by the counter tops,
doors, drawers, or grills.
Fig. 1. Remove the exterior packaging.
Fig. 3. Shipping bolt locations.
Fig. 2. Remove the glass swing door shipping bracket, if so equipped. Do not
discard.
To Next Page
Loading...
Need help?
General
