True GDM-49 - Installing Trueflex Bottle Organizers

............ www.truemfg.com ............
True Food Service Equipment, Inc.
24
24
NOTE
When installing shelves, be sure to plan
adequate space between shelves for
product to be stocked and removed.
Step 1
Installwireshelvessorearshelfclipsarefourslotshigherthan
frontshelfclips(forgravityfeed).Topreventshelvesfrom
slidingforwardbesuretoinstallshelfretainerclips(image1).
Step 2
PlaceTrueFlexorganizeralongtankside.Guide 
bottomtabsbetweenthefirstandthirdwire  
supportsasshown(image2).
Step 3
Firmlypressandslidehandalonginsideof  
TrueFlexorganizeruntilitsnapsinplaceontopof 
shelf(image3).Tabsgripbetweenshelfwire 
supports(image3a).
Step 4
LineupsecondTrueFlexorganizeragainsttheside 
ofthefirstoneandpressintoplaceasbefore. 
Continuetheprocessuntilshelfisfilledout  
(image4).
NOTE
Organizers may not fill entire width of shelf.
INSTALLING BOTTLE ORGANIZERS (20 OZ.)
INSTALLATION / OPERATION INSTRUCTIONS
Shelf retainer clip installation,
both sides. (retainer clip
position varies depending on
model, GDM-12 shown)
Guide bottom tabs
between first and third
wire supports.
Press organizer down until
bottom tabs snap into
place between shelf wire
supports.
Tabs snap in place under
wire shelf supports.
Organizers in place.
Organizers merchandised
with 20 oz. bottles.
1
2
3
3a
4
5