! This machine should not be operated be
persons of limited capacity
! Do not operate the machine if under the
influence of alcohol, prescription medicine or
any substances which may impair your
judgement
! Be wary of your environment, do not operate
the machine in adverse weather conditions.
Clear any obstacles from the working area
Storage instructions
If the unit is to be stored for long periods of time
please read the following –
• Drain the oil and fuel tank, fuel vapours can
build up and pose a fire hazard
• Remove and clean the blade
•
Wipe the machine down with a cloth soaked
in a mild soapy solution and dry fully
• Store in a dry place
• Keep in a locked area and keep out of the
reach of children
• Allow the engine to cool before storing
• Ensure all fixings are tight on the unit
Inspection and maintenance
Regularly check:
• The air filter
• The spark plug
• The bump head / brush cutter blade
Fuel pipe / tank grommet exchange
! Please ensure the unit is completely drained of
fuel before attempting this procedure.
• Unscrew the retaining cap and remove
the air filter cover. **The retaining cap
will be a Philips screw on certain
models**
• Remove the fuel pipes from the
carburettor using long nosed pliers and
a small flat headed screwdriver, noting
the location of each pipe before
removal.
Black pipe = Feed/Supply
Clear Pipe = Return
• Unscrew the fuel cap and remove it by
pulling the retaining strap from inside
the fuel tank.
To Next Page
Loading...
