EasyManuals Logo

Truma Mover XT L User Manual

Truma Mover XT L
10 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
3
General instructions
The Mover®XT L has been designed to cope with inclines of
up to approx. 25 % bearing a gross weight of 1200 kg or 20 %
bearing a gross weight of 1500kg on a suitable surface.
Depending on the weight of the caravan, the Mover®XT L may
not be able to overcome obstacles more than about 3cm in
height without auxiliary equipment (please use ascent chocks).
As a result of the characteristic properties of a radio signal, it
may be interrupted by terrain / objects. This reduces reception
quality in small areas around the caravan, as a result of which
the operation of the Mover®XT L may be briefly interrupted.
When the Mover®XT L is switched off using the remote
control, the control unit remains in standby. In order to
switch off completely the battery must be disconnected or an
isolating switch installed.
Batteries
Recommended battery capacities
Button cell technology at least 38 Ah
Gel / AGM at least 48 Ah
Lead-acid battery (liquid electrolyte) at least 75 Ah
Starter batteries are not suitable
Batteries with greater capacity allow the equipment to
be used for longer.
Charger
For optimum battery charging we recommend the Truma
BC10 charger, which is suitable for all battery types up to
200Ah.
Battery care (including maintenance-free
batteries)
In order to achieve a long battery service life, attention must
be paid to the following points:
Batteries should be fully charged before and after removing
power,
for stationary periods of longer than 24 hours, interrupt
power circuit (e.g. using circuit breaker or by disconnecting
the battery poles),
for longer stop periods the battery must be disconnected
and charged for 24 hours at least every 12 weeks.
In winter, store fully charged battery in a cool and
frost-free place and recharge at regular intervals (every
12weeks).
Function description
Always observe the operating instructions and the
“Safety instructions” prior to starting! The vehicle owner
is responsible for correct operation of the device.
Please note that the Mover®XT L is only suitable for
single-axle trailers.
The Mover®XT L is a manoeuvring system which allows a cara-
van to be manoeuvred without the aid of the towing vehicle.
It consists of two separate drive assemblies, each with its
own 12V DC motor. These units are mounted on the frame
of the vehicle in the immediate vicinity of the wheels, and are
connected by a lateral bar.
Once the drive rollers have been engaged using the remote
control, the Mover®XT L is ready for operation. It is operated
exclusively via the remote control, which transmits radio sig-
nals to the control unit. A separately installed 12V lead-acid
battery or suitable lead-gel battery (not supplied) provides the
control unit with electrical power.

Other manuals for Truma Mover XT L

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Truma Mover XT L and is the answer not in the manual?

Truma Mover XT L Specifications

General IconGeneral
BrandTruma
ModelMover XT L
CategoryAutomobile Accessories
LanguageEnglish

Related product manuals