TruPace E 200 - Step 5: Connecting Tubes & Handlebars

Step 5:
A. Attach the left pedal connecting to tube (69L) to the left lower handlebar (44L) by using 1
x M10*78mm Allen bolt (68), 1x Ф10*19*2t mm flat washer (53), and 1x M10 nut (75).
B. Attach the left pedal connecting tube (69L) to the left pedal arm (71L) by using 1 x Fixing
plate (102), 3 x M8*20mm Allen bolt (17), 3 x Ф8 spring washers (20), 3 x Ф8*19*1.5mm
flat washer (34).
C. Tighten all bolts now.
D. Attach the decorative cover (54L) to the lower handlebar (44L) by using 2 x M5*15
round head screw (36)
E. Repeat the process above for the right side
F. Attach the stationary handlebar (13) to the handlebar post (49) by using 2 x M8*20
Locking Allen bolts (9) and 2 x Ф8*19*1.5t curved washers (16). Tighten bolts now
G. Insert the left upper handlebar (1L) into the left lower handlebar (44L) and secure by
using 2 x M8*20mm Allen bolt (17), 2 x Ф8 spring washers (20), 2 x Ф8*19*1.5t curved
washers (16).
H. Repeat the process above for the right side
I. Tighten all bolts now.
Owner’s Manual 8
16
17
69R
69L
69R
69L
69L
71L
71L
102
20
34
17
44L
44R
44R
54L
54R
36
68
53
75
9
16
13
49
49
13
71R
20