Self Test and Dump Mode
This utility is used to use slef test function to see the setting of the printer. Please follow below steps to activate the function:
Install the label first > Press the FEED button>Turn on the printer power >The printer will performs the following items:
1. Calibrate label pitch
2. Print out thermal print head check pattern
3. Print the internal settings
4. Enter dump mode
Dump Mode
After the self test, the printer enters the dump mode. In this mode, any characters sent from the host computer will be printed
in two columns.The characters received will be shown in the first column, and their corresponding hexadecimal values will be
shown in the second coloum. Reset the printer by turning the POWER switch off and on.
Hex decimal data related to left
column of ASCII data
To Next Page
Loading...
