19
TROUBLESHOOTING TIPS
TST-Doc-507FT-RV WSD-C Manual-(D)
Ÿ Label all of your sensors with the provided stickers first so you will know which
sensor goes in which tire position.
Ÿ If a sensor is not allowing air to pass through it, or if the sensor is not reading,
or reading a lower pressure, try unscrewing the valve core in the valve stem
slowly until you hear air leaking a little. Stop unscrewing the core and screw it
back in slightly, just enough to stop the air leak. This will allow more air to get
to and through the sensor. CAUTION...Do not stand in front of the valve stem
when performing this procedure with a valve core tool!
Ÿ It may take up to 15 minutes for the sensor data to appear on the display the
first time you set up the system. Leave the display on until all sensor data
appears. After the sensor data is received the first time, subsequent system use
should only take minutes to acquire the sensor information.
Ÿ Do not over tighten the sensors on the valve stems. Make sure they are snug
and be sure to tighten the hex lock nut to the bottom of the sensor.
Ÿ When done programming the Parameters into the display, remember to quickly
push the "SET" button to save the Parameters. Push the "BACK" button twice to
go back to the Main Screen.
Ÿ If your tire pressure is under 100 PSI, you will have to program the Low-
Pressure alarm first and then program the High-Pressure alarm. The high
pressure cannot go lower than the low-pressure setting, which defaults to 100
PSI.
Ÿ When the display is on and reading, you can press the (+) or (-) buttons to
quickly scroll through the tires on your display. The automatic scrolling function
will resume after 10 seconds when no buttons are pushed.
Ÿ If your display is plugged into a constant power source, the sliding power
switch on the side will not function. To turn the display off, unplug the power
supply and the switch will now operate.
Ÿ To extend the life of the sensor battery, remove the sensor from the valve stem.
The internal pressure switch will shut the battery off. Note that, even though
the battery is off, it will still degrade with time.
Ÿ If your sensor is not transmitting data to the display, try recoding the sensor to
the same tire position. See Automatic Code Learning (Option #1) on page 4.
To Next Page
Loading...