RESTORE PARAMETERS TO FACTORY DEFAULT SETTINGS
DISPLAY ALERTS
TST-Doc-507FT-RV WSD-C Manual-(D)
Out of Parameter Alert
The sensors send the tire pressure and temperature readings to the display every
five (5) minutes. If a tire is outside of the parameters that were set, the audible
alarm will sound and the red LED light will immediately flash. The tire in question,
pressure or temperature for that tire, and warning type will also flash. The audible
alarm can be silenced for a short while by pushing any of the buttons on the front
of the display. The red warning light will continue to flash until the pressure or
temperature issue is resolved and brought back into your preset levels.
High Pressure Alert
(e.g.: High pressure threshold is 175 PSI)
Note: < >&<HI PRESSURE>displayed, the
faulty tire pressure is too high, deflate
the tire to the normal pressure.
Low Pressure Alert
(e.g.: Low pressure threshold is 100 PSI)
Note: < >&<LO PRESSURE>displayed, the
faulty tire pressure is too low, inflate the
tire to the normal pressure.
First, turn off the display. Hold the "BACK" and "SET" buttons at the same time and
turn the display back on. You will hear one beep. The display will power back on
and original factory parameters will be restored. Tire codes will not be erased or
changed.
High Temperature Alert
(e.g.: High temperature threshold is 158°F)
Note: < >&<HI TEMP>displayed, the faulty
tire temperature is too high, stop vehicle
to cool down to the normal temperature.
To Next Page
Loading...