Need help?Do you have a question about the Tsurumi Pump KTZ series and is the answer not in the manual?
Manual contains WARNING, CAUTION, ATTENTION, COUNTERMEASURE callouts for safety.
Diagram illustrating the components of a typical KTZ submersible pump.
Checks to perform before operating the pump after delivery.
Key technical specifications for the pump and motor components.
Detailed specifications table for KTZ series pumps operating at 60 Hz.
Guidance on tools, preparation, and steps for installing the submersible pump.
Instructions for safe and correct electrical connections, including grounding.
Diagrams illustrating the direct-on-line starting electrical circuits.
Procedures for trial operation, checks, and normal pump operation.
Guidelines for periodic maintenance, inspections, and part replacement.
Step-by-step procedures for taking apart and putting back together the pump.
Common problems, their causes, and recommended solutions for the pump.
Pre-installation checks specific to the KTZE Series operation manual.
General| Model | KTZ series |
|---|---|
| Power Source | Electric |
| Type | Submersible Pump |
| Motor Power | Varies by model (0.75 kW to 30 kW) |
| Voltage | 220V, 380V, 400V, 415V, 440V |
| Frequency | 50 Hz or 60 Hz |
| Phase | Three-phase |
| Material | Cast iron |
| Impeller Material | High-Chrome Cast Iron |
| Impeller Type | semi-open |
| Seal Type | Mechanical seal |
| Discharge Bore | Varies by model (50mm - 100mm) |
To Next Page