TCB-900
English4
Introduction
1. Introduction
2. Supplied Accessories
3. Installation
TCB-900 transceiver is designed to have a good performance in any
conditions that the transceiver operates, using rugged build chassis,
PCB’s and components. This transceiver is also designed for users’
convenience, implementing human ergonomics to locate the knobs
and buttons in the proper places. The combination of well designed
knobs and buttons as well as user friendly graphic layouts will lead
users to quickly adapt themselves for the easy operation. The newly
applied menu mode will make professional users more satisfactory
with pleasure. The elegant luxury and color changeable LED light
supporting the face design will go well with any vehicles.
This instruction manual has been designed to enable you to get the
best use from your CB Transceiver, therefore you are recommended
to take a few minutes to read this instruction manual before initial use
of your CB Transceiver.
Plan the location of the transceiver and microphone first, which is
most convenient for the operation. The transceiver should normally
be mounted horizontally, but may be mounted vertically. The bracket
supplied can be fitted above or below the case allowing the TCB-900
to be cradled by the bracket or suspended from it.
Your transceiver is supplied with a full range of accessories to help you
get started and virtually benefit from all the features straight away.
TCB-900 transceiver 1 unit
Microphone with cord 1 unit
Power cable 1 unit
Radio mounting bracket 1 unit
Radio mounting thumb screw with rubber washer 2 pieces
Mounting screw & washer(for transceiver bracket) 3 pieces
Mounting screw & washer(for microphone bracket) 3 pieces
Microphone mounting bracket 1 piece
To Next Page
Loading...
