get into an endless loop. Don’t worry; just press the key to stop the program
running.
TIP: To completely redefine a procedure that you have already written, simply use
‘New Proc’ instead of ‘Edit proc’ and Pro-Bot will clear the procedure for you.
Menu System
Using the menu key gives you access to a number of other functions within Pro-Bot.
Special commands can be added to your program, different configuration options can
be selected and procedures can be managed.
The Menu system is entered by pressing the key above the display. You are then
given a list of menu selections. The first in the list is always <Back>, which allows you to
go back one level of the menu. Use the up and down scroll keys to move the highlight
to the menu item you want to select, then press again to select that item.
The Menu system is structured as follows:
Back Goes back one level
New Proc
o <Select> Edit procedure with empty program
Edt Proc
o <Select> Edit procedure with existing program
Config
o Units
Cm Units are in Cm
Pro-Bot Units are in Pro-Bot lengths
o End of Cmd
Beep on/off Enable beep after commands
Pause on/off Enable pause after commands
Sensors (NB. in version 1 all sensors are enabled together)
o Touch on/off Enable both touch sensors
o Sound on/off Enable sound sensor
o Light on/off Enable light sensor
Clear
o Clr Main Clears Main procedure only
o Clr Proc Clears specified procedure
o Clr All Clears the whole program
To Next Page
Loading...
