HTX-2000 Dual Stack-Funtional Trainerwww.tu stu tness.com
22
Weight stack label and lubrication instructions
1. Wipe front surface of weight stack with rubbing alcohol and wipe dry.
2. Peel o back sheet (adhesive side) from label #129 and make sure that the labels remain
attached to the application tape.
3. Line up hole on the second label to hole on the rst weight plate.
4. Make sure the hole on the last label lines up with last weight plate and slowly press into
place.
5. Gently remove application tape and rub each label rmly against the weight stack.
6. Once this is complete, repeat this procedure for top plate label.
6. Allow labels to stand for 2 days to allow adhesive to cure fully.
7. Open the lube package provided and apply a thin lm of lubricant around the rst 3 inches
of the guide rods above the top plate.
8. After the cables are installed, do a set of reps to spread the lubricant thoroughly.
NOTE:
1. TOP PLATE LABEL GOES ON HOLE OFF CENTER AS
SHOWN. LABEL WILL COVER HOLE ON CENTER.
2. FOLLOW THESE INSTRUCTIONS FOR BOTH WEIGHT STACKS.
Step 11
To Next Page
Loading...
