9
Hold
There are 4 different hold functions you can choose from in the C11 parameter
1. Peak Hold: Grabs the highest weight (for materials testing, ie. tension and pulling
force)
● Press the HOLD key then add weight to the scale
● The indicator will show the highest weight it recorded and hold it on the screen until
a higher weight is placed on the scale
2. Manual Hold: Grabs the current weight and holds it so it will not change/uctuate
● While weighing, press HOLD and the indicator will hold the current weight on the
screen until HOLD is pressed again
3. Auto Hold: If the weight on the scale is above 20d (20 x division) and is stable,
the indicator will hold that weight on the screen for 3 seconds then go back to general
weighing
● Pressing the hold key is unnecessary, holding is done automatically when the scale
is stable
4. Average Hold: Used for animal weighing, the indicator will display the average
weight sampled from 3 seconds
● Add livestock to scale and press HOLD
● Indicator screen will show “
LOC
” for 3 seconds, then display the average weight
from those 3 seconds
● Press HOLD again to exit holding mode
Print
● If the indicator is connected to a printer and the weight on the scale is stable press the
PRINT key to print the current weight
● In accumulation mode hold the PRINT key for one second when the last 4 digits of the
total weight are shown to print the total weight
Note: In tare mode the printer can not print if negative weight is shown
To Next Page
Loading...
Need help?
General
