What to do if my Tufner T900 show ERR3?
If your Tufner Measuring Instruments display 'ERR3', first, check all wire connections. If the issue persists, inspect the load cell and recalibrate the device. If these steps do not resolve the problem, PCB replacement may be necessary.
What to do if my Tufner T900 show ERR1?
If your Tufner Measuring Instruments display 'ERR1', ensure that you are using the correct weight within the defined range of the instrument.
What to do if my Tufner T900 show ERR2?
If your Tufner Measuring Instruments display 'ERR2', ensure that the calibration weight is at least 10% of the maximum capacity set in C04. It is recommended to use 60%-80% of the maximum capacity, if possible.
Why does my Tufner T900 display UUUUUU?
If your Tufner Measuring Instruments display 'UUUUUU', it could be due to several reasons: the weight might be too high (overload), there could be a wrong connection with the load cell, or the load cell itself may have a quality problem. To resolve this, first, reduce the weight on the instrument. Then, check the load cell connection. Finally, inspect the load cell and check its input/output.
What to do if Tufner T900 show nnnnnnn?
If your Tufner Measuring Instruments display 'nnnnnnn', there could be a few reasons: the calibration might not be correct, there may be a wrong connection with the load cell, or the load cell itself might have a quality issue. To address this, first, make sure the scale is level. Next, check the load cell connection. Then, check the load cell's input and output resistance.
What to do if Tufner T900 Measuring Instruments show ERR4?
If your Tufner Measuring Instruments display 'ERR4', make sure the platform is stable before you start the calibration process.
How to fix ERR5 on Tufner T900?
If your Tufner Measuring Instruments display 'ERR5', you will need to change the PCB.
Specific measures to prevent electrostatic discharge and protect equipment.
Detailed specifications including accuracy, resolution, and environmental limits.
Guidelines for charging, discharging, and maintaining the rechargeable battery.
How to use the tare function to exclude container weight and get net weight.
Procedure for setting a specific tare weight value before weighing.
Performing calibration using a single known weight for setup.
Setting the primary unit of measurement (kg, lb, gram, oz).
Adjusting display decimal places and readability of graduations.
Defining maximum capacity and selecting calibration methods.
Setting the communication speed for serial data transmission.
Adjusting filters for moving weight and scale stability parameters.
Customizing print mode, carriage return, and date/time inclusion.
Definitions for terms like Division, Capacity, Zero Range, and Filters.
Details on quick disconnect and hardwire methods for load cell connection.
Introduction to the different output formats available for the indicator.
Explanation of data bits, stop bits, parity, and handshaking settings.
Description of the data structure including states A, B, and C.
Using ASCII commands to control the indicator and retrieve data.
Printing formats for Tufner and Zebra label printers.
Steps to calibrate the 4-20 mA analog output signal.
Relay output settings and DB9 pin definitions for connection.
Table listing error codes, their reasons, and suggested solutions.
Specific solutions for scale not turning on, negative readings, and error codes.
General| Brand | Tufner |
|---|---|
| Model | T900 Series |
| Category | Measuring Instruments |
| Language | English |
To Next Page
