7
C45 - OWNER’S MANUAL ENGLISH
increasing in intensity until the closing phase of the prole.
This prole is specically suitable for the physically t. With
default setting, max. Watt value is 210, average
Watt value is 133.
0
25
50
75
100
125
150
175
200
225
PROFILE P5. Interval effort prole with regular changes and
a clear difference between peaks and the basic level of
effort. The default values are preset to an average effort
of 138 W and a maximum effort of 200 W. Please note that
this prole allows you to separately adjust the peaks and
the basic level of effort.
0
25
50
75
100
125
150
175
200
225
P6-P10 ARE TARGET HEART RATE PROGRAMMES
PROFILE P6. 3-peak heart rate prole for the improvement
of oxygen uptake capacity. With
relatively long-lasting peaks, this prole is suitable for
beginners. With default setting, max. HR value is 125,
average HR is 112.
PROFILE P7. Uphill heart rate prole where the heart rate
increases steadily until the midpoint of the prole, steadily
decreasing thereafter. This prole is suitable for beginners.
With default setting, max. HR value is 150, average HR is 121.
PROFILE P8. 3-peak heart rate prole for the improvement
of endurance tness. Peaks are relatively long-lasting, but
the heart rate level remains fairly constant throughout. This
prole is suitable for all tness levels. With default setting,
max. HR value is 140, average HR is 120.
PROFILE P9. Uphill heart rate prole for the improvement
of endurance tness. Peaks are relatively long-lasting,
increasing in intensity until the closing phase of the prole.
This prole is specically suitable for the physically t. With
default setting, max. HR value is 165, average HR is 131.
PROFILE P10. 3-peak heart rate prole for the improvement
of oxygen uptake capacity. Peaks are relatively long-
lasting, with each followed by a steady recovery period.
This prole is specically suitable for the physically t. With
default setting, max. HR value is 160, average HR is 133.
T-TRAINER™
T-Trainer™ is a new training mode for ellipticals. There
are 6 different movements, which enlarge the traditional
cardiovascular training to muscle training areas.
T-Trainer™ has 6 preset training modules. Each training
programme starts with the Arm Push module. After each
training programme module there is always cooling down
period (Free Ride). While in Free Ride mode the user cools
down from the previous training module and prepares for
the next. There are 6 different T-Trainer™ training modules.
The default resistance for each training module has been
preset, but can be scaled (adjusted) using the jog wheel.
Scaling modies the remainder of the training programme.
The movements are always repeated in same order as
follows: Arm Push, Arm Pull, Pedal Forward, Pedal Backward,
Lean Forward and Squat. The rst training module is referred
to as 1/6, the second 2/6 etc. After every training module
there is cooling down training, Free Ride.