turck TBEN-LG-16DXP - Ethernet Ports and Device Fault LEDs

TBEN-LG EtherNet/IP
TM
Configuration Guide
TURCK • 3000 Campus Drive • Minneapolis, MN 55441-2656 12
Phone: 763.553.7300 • Toll Free: 800.544.7769 • Fax: 763.553.0708 • www.turck.us
Ethernet Ports and Device Fault LEDs
LED Status Description
LD_P1 and LD_P2 (same functionality for all device types)
off No Ethernet link
LD_P1 , LD_P2 green on Link 100MBit. The LED flashes during data transfer.
( yellow / green ) yellow on Link 10MBit. The LED flashes during data transfer.
yellow on / green on Not valid state
LD_BUS (same functionality for all device types)
off No supply voltage
green on Active connection to a master
LD_BUS green blinking Ready for operation
( red / green ) red on
IP address conflict is detected or restore mode (0 /
900 switch position),
red flashing
Blink / Wink is active (command sent from the IO
assistant, IP address tool)
alternating
red on / green on
Auto-negotiation and/or DHCP/BOOTP waiting for IP
address assignment
LD_ERR (same functionality for all device types)
off No supply voltage
LD_ERR green on Normal operation
( red / green ) red on Diagnostics active
red on / green on Not valid state