How to troubleshoot a TURNTIDE Fan that will not start?
If your TURNTIDE Fan isn't starting, begin by checking the fuses and circuit breakers. Then, inspect the wire connections to the motor for any bad connections. Finally, check the voltage at the fan connection to ensure there isn't over or under voltage.
Why is my TURNTIDE Fan making noise?
If your TURNTIDE Fan is making noise, it could be due to several reasons. First, check the motor case to ensure all visible screws are snug. Next, make sure all blade bracket screws are tight and that the fan/guards are secured. Also, check the bearing shaft to ensure the blade spins freely without noise, which could indicate a bad/worn bearing or debris.
What to do if my TURNTIDE Fan is running too fast or slow?
If your TURNTIDE Fan is running too fast or too slow, check the voltage at the motor and ensure it is wired for the correct voltage. Also, verify that the environmental control settings are correct.
How to fix a TURNTIDE Fan that wobbles or vibrates?
To address a wobbling or vibrating TURNTIDE Fan, first, check that all blade paddles are screwed firmly to the spyder. Next, run the fan without the blade; if the motor doesn't wobble, the blades may be damaged. Finally, check for a worn bearing shaft.
Explains the meaning of DANGER, WARNING, CAUTION, and NOTICE symbols used in the manual.
Provides essential safety practices for handling and working with the fan and electrical components.
Covers general unpacking procedures, including inspecting for damage and handling precautions.
Lists the necessary tools required for unpacking and initial handling of the fan.
Specifies the required dimensions and measurements for the fan's rough opening in the structure.
Details the mounting procedure for the Actuated Shutter Kit (ASK) onto the fan assembly.
Provides dimensional data related to the fan's cross-sectional width and components.
Illustrates and details the configuration and spacing of multiple fan assemblies.
Instructions and tools for installing the outlet guard onto the fan assembly.
Steps and tools required to install the Inside Deflector Kit (IDK).
Guidance on installing the inlet guard, including necessary tools and steps.
Procedures for installing the Actuated Shutter Kit (ASK) onto the fan.
Explains how to read and interpret information found on the motor's identification label.
Provides a detailed wiring diagram for connecting the motor to the power supply and control.
Details the motor control unit, including its dimensions, mounting orientation, and drip loop requirements.
Describes the meaning of various LED indicator states on the motor control for troubleshooting.
Refers the user to a separate manual for information regarding sensors.
Specifies daily, monthly, and yearly maintenance tasks for the fan and its electrical wiring.
Details the cleaning and inspection procedures for fan blades and hub.
Lists the maintenance tasks for specific fan attachments like guards, deflectors, and shutters.
Provides overall guidelines for inspecting and maintaining the fans, including routine checks and preventing obstructions.
Details the individual parts that constitute the base fan assembly, with their respective part numbers.
Provides part numbers and quantities for the outlet guard and its hardware.
Lists the components and part numbers for the Inside Deflector Kit (IDK).
Shows the part number and quantity for the inlet guard assembly.
Details all components and part numbers included in the Actuated Shutter Kit (ASK).
Details the one-year warranty, specific warranties, limitations of liability, and disclaimers.
Explains the process for filing warranty claims, returning products, and handling shipping.
General| Finish | White |
|---|---|
| Model | PPFD72 |
| Blade Span | 72 inches |
| Mounting | Ceiling |
| Category | Ceiling Fan |
To Next Page