Turtle Beach ear force w3 - User Manual

For more products, accessories, and our support
knowledge base, visit www.turtlebeach.com
Operating Instructions
Connecting TV / Music Players
Connecting to
Headphone Jacks
W3
Wireless Wii Headphones
®
TM
The W3 may be used for listening to
other audio sources, such as the output
of your TV, the output of your PC sound
card, an MP3 player, home theater
system, etc. In each case, simply connect
the output of the audio device to the
audio input jack on the base unit and set
the level control for optimum listening
volume.
Use an optional 3.5mm to dual RCA
stereo splitter cable to connect your
wireless W3 headphones to standard
3.5mm headphone jacks, such as an
Ipod®, MP3 player, TV output, etc.
Connecting the Wii
Connect the transmitter, Wii and TV
or sound system as shown below.
This will allow you to hear the Wii with
either your sound system or W3
headphones.
Wii
Transmitter
Important: Do not put transmitter unit close
to the Wii sensor bar.
TV or Sound System
Package Contents
• W3 wireless headphones
• Transmitter base unit
• DC power adapter
• 1 AAA battery
• This User's Guide
For warranty information please visit
http://support.turtlebeach.com
Copyright © 2010 Voyetra Turtle Beach, Inc. (VTB, Inc.) All rights
reserved. No part of this document may be reproduced without
permission. The Turtle Beach Logo, Ear Force and Turtle Beach are
registered trademarks of VTB, Inc. Nintendo is a registered trademark
and Wii is a trademark of Nintendo. All other trademarks are
properties of their respective companies and are hereby
acknowledged. Product features, visual design, prices, package
contents and specications are subject to change without notice.
Part# TBS-2090 V1
The W3 headphones are powered by
1 AAA battery (included) located in the
left ear cup. Lift the battery cover and
insert the battery before operating the
headphones. Then turn the power switch
on the right ear cup to the "on" position.
Installing the Battery
Connecting the Power Adapter
The W3 base unit is powered by a DC power
adapter, (included). Insert the power adapter
into the power jack on the back of the
base unit.
When the adapter is inserted into the base
unit and plugged into a wall socket, a red
light on the front of the base unit will light
up to indicate that power is active.
CAUTION: Use only the supplied power adapter.
Failure to use the correct adapter can result in fire,
damage to the unit or other hazards.

Summary

Getting Started with Your Turtle Beach Ear Force W3 Headphones

Installing the Battery

Instructions for inserting the AAA battery and turning on the headphones.

Connecting the Power Adapter

Guide on connecting the DC power adapter to the base unit and power indicator.

Connecting to Your Wii

Steps to connect the transmitter to the Wii, TV, or sound system.

Connecting to TV or Music Players

How to connect the W3 headphones to various audio sources like TVs or PCs.

Package Contents

Lists the items included in the W3 wireless headphones package.

Important Information and Settings

About the W3 Headphones

Overview of the IR technology used by W3 headphones for sound transmission.

Important Usage Information

Safety advice on volume control, power adapter use, and hearing protection.

Adjusting Wii Remote Sensitivity

Guide to adjusting Wii sensitivity settings to avoid interference from the transmitter.

Turtle Beach ear force w3 Specifications

General

Wireless	Yes
Frequency Response	20Hz - 20kHz
Driver Size	50mm
Impedance	32 Ohms
Battery Life	Up to 15 hours
Type	Over-ear
Connectivity	Wireless