EasyManua.ls Logo

Turtle Beach Stealth 700 Gen 2 - Technical Compliance: Class B, RF, and Canadian ICES

Turtle Beach Stealth 700 Gen 2
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Class B Interference Statement
RF Radiation Exposure & Hazard Warning
Class B Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. The limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment doesn’t cause
harmful interference to radio or television reception, which can be diminished by turning the equipment off and on,
the user is encouraged lo try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: [1] This
device may not cause harmful interference, and (2) this device must accept any interference received, Including
interference that may cause undesired operation.
RF Radiation Exposure & Hazard Statements
To ensure compliance with FCC RF exposure requirement, this device must be installed in a location such that the
antenna of the device will be greater than 2 cm (0.8 in.) from all persons. Using higher gain antennas and types of
antennas not covered under the FCC certification of this product is not allowed. Installers or the radio and and users
of the product must adhere to the installation instructions provided in this manual. This transmitter must not be co-
located or operated in conjunction with any other antenna or transmitter
Non-Modification Statement
Use only the supplied Internal antenna. Unauthorized anlennas, modifications, or attachments could damage the
StealthTM 700P Gen 2 RX & TX Models and violate FCC regulations. Any changes or modifications not expressly
approved by the party responsible for compliance could void the user’s authority to operate this equipment. Please
contact Turtle Beach for a list of approved 2.4 GHz antennas.
This product is compliant with the Consumer Product Safety Improvement Act of 2008, Public Law 110-314 (CPSIA)
Canadian ICES Statements IC:
3879A-3780 (RX) and IC: 3879A-3785 (TX)
This device complies with ICES-003 and RSS-247 of Industry Canada. Operation is subject to the following two
conditions:
1. This device may not cause interference, and
2. This device must accept any Interference, Including interference that may cause undesired operations of the
device.
To prevent radio Interference to the licensed service (I.e. co-channel Mobile Satellite systems) this device is Intended
to be operated indoors and away from windows to provide maximum shielding. Equipment (or its transmit antenna]
that is installed outdoors is subject to licensing and not supported by Stealth™ 700P Gen 2 RX & TX Models.
RF Radiation Exposure & Hazard Statement
To ensure compliance with RSS-102 RF exposure requirements, this device must be installed in a location such that
the antenna of the device will be greater than 2 cm (0.8 in.) away from all persons. Using higher gain antennas and
types of antennas not covered under the IC certification of this product is not allowed. Installers of the radio and end
users of the product must adhere to the installation instructions provided in this manual. This transmitter must not be
co-located or operated in conjunction with any other antenna or transmitter.
European Union and European Fair Trade Association Regulatory Compliance
This equipment may be operated in the countries that comprise the member countries of the European Union and the
European Fair Trade Association. These countries, listed below, are referred to as The European Community
throughout this document: AUSTRIA, BELGIUM, BULGARIA, CYPRUS, CZECH REPUBLIC, DENMARK, ESTONIA,

Related product manuals