17
Now remount the tire back onto the wheel, being careful not to damage the tire pressure sensor during
mounting of the tire. Each TPMS retrofit kit comes with a wheel orientation mark sticker sheet to easily
identify wheel location on the receiver display and for which vehicle selection.
To apply the sticker to the wheel, clean the surface of the wheel
near the valve stem with isopropyl alcohol and allow to dry
completely. Do not use brake cleaner or other harsh chemical
solvents to prepare the wheel surface for sticker application.
Make sure the wheel surface is clean and dry then adhere the
corresponding wheel ID sticker to the clean surface near the valve
stem. This will help remind technicians to install the wheel back
to the correct location according to your defined wheel position.
Lastly, balance the wheel as you would normally, adding weights
if necessary, to achieve rotational balance.
To Next Page
Loading...