Tuson TPMS - TPMS Receiver Installation

23
secure the repeater. If using the foam adhesive pad to mount the repeater on a trailer frame
member, we recommend using at least two screws to fasten the repeater to act as a backup in
case the adhesive loses its grip over time.
5.2.4 After securely mounting the repeater to the trailer, route the power wires to the trailer battery.
Mount the O-ring connectors on the repeater’s power wires to the proper trailer battery terminals.
Connect the RED O-ring terminal to the POSITIVE (+) battery terminal and the BLACK (-) O-ring
terminal to the NEGATIVE (-) battery terminal.
5.2.5 Use the cable ties to avoid a loose repeater power cable by fastening the repeater power cable to
the frame of the trailer or 5
th
wheel. Avoid overtightening cable ties to prevent cutting into the cable.
6. TPMS Receiver Installation
6.1 Receiver Image