Tuson TPMS - Troubleshooting

62
10. Troubleshooting
Issue
Probable Causes
Solution
Tire Sensor ID Paring failed
(TPMS alarm with a long beep in
rapid deflation learning setting)

Wireless signal
interference
 Tire air pressure is not
deflated enough

Move receiver to another
area
 Keep deflating the tires for
20~30 seconds
Pressure anomaly warning
(TPMS alarm with short beeps)
 Low tire pressure
 Please inflate the tires to
the correct pressure to
prevent an erroneous alarm
No signal received
(Screen shows pressure and
temperature as green dash lines “- -
“ and corresponding wheel number)

Signal interference.
 Vehicle has stopped or
is moving too slow
 Sensor is damaged or
low battery power
 Repeater could be
damaged

Move the tow vehicle away
from the current area
 Pick up speed of over 12
mph/20 kph to “wake up”
sensor and continue driving
for a few minutes
 Go to a qualified service
shop for installation of a new
sensor on your wheel
 Check that the repeater is
powered