12
4. TPMS Sensor Installation
<IMPORTANT 1>
Each sensor has a unique Sensor ID# to identify the sensor to the receiver. The
sensors included in the kit are already paired to the receiver from the factory for
ease of installation and have a designated wheel orientation mark (□
1
,□
2
,…□
6
) on
the sensor (see Figure 4.1). The wheel orientation mark on each kit sensor
corresponds to a tire location on the vehicle and/or trailer. It is important to install
the kit sensors to the corresponding wheels on the vehicle and/or trailer (see
Table 4.1 for reference). If the sensors are installed in the correct corresponding
wheel locations in Table 4.1 for up to six (6) sensors, then you can skip Setting
“8.5 Tire Sensor ID Pairing to the Receiver” from Section “8. Settings Mode
Menu” (Note: If installing additional sensors not included in the kit, the “8.5 Tire
Sensor ID Pairing to Receiver” must be performed for the additional sensors only.)
Orientation Mark
To Next Page
Loading...