Need help?Do you have a question about the Tuthill HD Series and is the answer not in the manual?
General| Series | HD Series |
|---|---|
| Application | Water |
| Seal Type | Mechanical Seal |
| Power Source | Electric Motor |
| Material | Cast Iron |
Details the design and capabilities of Tuthill Industrial Series pumps, highlighting their ability to handle viscous, abrasive, or corrosive fluids without degradation.
Explains the operational mechanism of the pumps, detailing how rotating impellers create vacuum, displace material, and ensure positive flow.
Details how the pump's flow direction is determined by the drive shaft rotation for different model series.
Provides instructions on adjusting pump packing for proper leakage control and longevity, emphasizing gradual tightening and monitoring.
Outlines the lubrication needs for faceplate bearings, housing bushings, and gear case bearings, including specific oil and grease types.
Specifies the oil and grease types and their properties required for Tuthill process pumps, including viscosity and additives.
Step-by-step guide for minor disassembly focusing on fluid chamber inspection, including gear and shaft handling.
Procedures for checking shaft alignment and impeller condition within the fluid chamber.
Detailed steps for reassembling pumps after major disassembly, including impeller and bearing installation.
Step-by-step guide for minor disassembly of 600 series pumps, focusing on fluid chamber inspection.
Procedures for checking shaft alignment and impeller condition for 600 series pumps.
Detailed steps for reassembling 600 series pumps after major disassembly, including impeller and bearing installation.
Instructions for installing packing rings into pumps, ensuring proper fit and staggered joints for optimal performance.
Guidelines for packing pumps used with abrasive liquids, including flushing and temperature control recommendations.
Steps for installing Tuffseal cartridge seals, ensuring proper alignment and securing of the seal assembly.
General procedures for installing mechanical seals, including stationary seat, gland, and working length setup.
Specifies the required torque for shaft locknuts on industrial models.
Details the applied torque values for various faceplate bolts based on pump model and bolt type.
Procedure for returning pumps to the factory, requiring RGA and MSDS submission.
Information on Tuthill's product warranty, coverage period, and exclusions.
Provides contact details for Tuthill Pump Group in North America and Europe for operational or maintenance information.
To Next Page