1、Please place the machine on a firm and flat ground.
2、Please add litter no higher than MAX line after placing the
machine well.
3、Please power on the machine and wait it to finish self-check.
Then itis ready for cat to use.
Cautions:
1.Please install and use this device strictly according to the instructions.
2.Please use it in an indoor environment, do not place it in direct sunlight, and keep it away
from fire sources.
3.Please place the device on a flat and hard ground, and do not place articles on the top of the
device.
4.Do not drag or place vigorously during placement to avoid device damage.
5.Kittens weighing less than 1kg and lactating cats should not use the auto cleaning mode of
the device.
6.lt is strictly forbidden to soak or immerse the host part of this device.
7.Please unplug the power cord when moving,cleaning the device or not using it for a long time.
8.Please use the original power adapter to avoid damage to the device or potential safety hazards.
9. If children use this device, please make sure to use it under the guidance of an adult.
10. Please perform maintenance under the guidance of professionals to avoid all kinds of
damages.
11.If you encounter product use problems, please contact customer service.
12.Please read this manual carefully before.Once installed and used, it means that you have
carefully read and accepted the following safety instructions.
13.If the product does not work properly due to other unknown conditions, and you do not
have time to refer to the instructions, please restart the power.
EN EN
FOR THE FIRST USE
CONTENT
FOR THE FIRST USE……………………………………………………….....……01
Ⅰ INSTRUCTIONS FOR THE FIRST USE ……………………………...…………03
Ⅱ APP…………………………………………………………………................07
Ⅲ OPERATING INSTRUCTIONS …………………………………………………11
Ⅳ FAULT SELF-CHECK METHOD ……………………………......………………28
Ⅴ FAQ …………………………………….……..............................................29
Ⅵ PRODUCT LIS …………………………………………………………………31
Ⅶ INTRODUCTION OF CONTROL PANEL ……….………………………………32
Ⅷ CIRCUIT DIAGRAM……………………….....…………………………………33
Ⅸ PARAMETERS AND SPECIFICATIONS …..……………………………………34
01 02
To Next Page
