1.4 Add litter sand:
Make sure the leveled litter height is between the MAX line and the
MIN line.(The amount of sand can be adjusted according to the actualsituation.)
1.5 Use:
1.5.1 Power on with adapter and wait the machine to self-check for about
3-8 minutes.It will automatically enter the state of sensing after
self-check, no need to change its program.
1.5.2 After the cat leaves, the product will automatically clean up the
clumped cat excrementin about 3 minutes,last for 4 minutes.
1.5.3 After cleaning, the product will automatically start the smell
cleaning function, and last for 30 minutes.
Notice:
Pick up or drag the product after powering up.(This will interfere with weight calibration in
the reset program.)
①If you place the product in a narrow space or there is an infrared interference source in front
of the product, the product self-check may take about 8 minutes.Please wait patiently.
②If the product detected that the space is not suitable for its infrared sensor to work, the
infrared detection function will be automatically disabled after self-check is completed.But
the weight detection system inside the product will assume the judgment work of whether
the cat enters.
③During the clearing process, all keys are suspended. If you need to perform other functions,
please wait until the clearing process is complete.
MAX Line
The amount of cat litter
should not exceed Max line
MAX
MIN
MIN Line
The amount of cat litter should
not be lower than Min line
EN EN
05 06
To Next Page
Loading...
