36 Multi Format LCD Monitor
7. Button Functions
● LVM series monitor supports various
analog input signals.
1. Press [ANALOG] in front of the monitor and
activate OSD menu as the left photo.
Select input you would like to use by Knob
or UP/DOWN KEY and press the knob.
2. There is current input signal on bottom of
OSD.
3. Press [ANALOG] again, then OSD menu
disappears.
#If no image displays after selecting the
desired input mode, check and make sure
that your connection is not lose or
disconnected.
<Warning!!>
When using ANALOG mode, always check
the input method and modify the setting as
needed for optimized output results.
[1] ANALOG
<LVM-182W/232W>
<LVM-176W/246W>
To Next Page
Loading...
Need help?
General
