The paper gets automatically fed and stops in the Top-of-Form position.
If necessary, make any adjustments for paper alignment with the Paper
Select Lever in the PIN Position; then return it to the FRIC position.
Press the Online Switch to set the printer to ONLINE Mode.
Note: Paper Park feature is available only with the Tractor in the Push Position.
CAUTION: If a job while printing on continuous stationery is interrupted,
to print another job on single sheets, make sure to erase previous job
from the buffer before you start printing on single sheets. This is done by
holding down the FONT switch for about five seconds in OFFLINE Mode.
You can print as many single sheets as wish. When you have finished, follow
these steps to reload continuous paper.
Give a Form Feed to eject any paper that may still be in the printer.
Set the Paper Select Lever in the PIN position and Tractor Select Lever in
the Paper Stack Position. This engages the tractor mechanism again.
Press the LF/FF switch to feed the continuous paper back into the printer.
The paper will stop at the current Top-of-Form position. The Online
Indicator LED will stop blinking.
Press the ONLINE Switch to set the printer in ONLINE Mode.
Now you are ready to print with continuous paper again.
50
To Next Page
