✦✦
✦✦
✦ Printing on Multi-part forms
Your printer is capable of printing multi-part stationery, up to four copies
(including original).
Set the paper thickness lever according to the number of copies you take.
Enable COPY Mode only when you are printing 1+3 copies.
Caution: If COPY Mode is enabled while printing in single sheet or other than
1+3 copies then the print head might be damaged.
Note: Do not use Rear Feeding or the Tractor in the Push Position, while
printing with multi-part forms. Use Bottom Feeding Paper path with Tractor
in Pull Position. This method allows the forms to feed through the printer
with minimum curling
51
To Next Page
