✦✦
✦✦
✦ PAPER FEEDING
PROBLEM:
Continuous stationary does not feed properly.
CHECKS:
Make sure the continuous paper is set in the tractors correctly
Be sure the paper select lever is in the correct position.
Make sure the paper is stacked properly Make sure the paper is loaded properly
as per the instructions given in the manual.
Make sure the paper thickness lever is set correctly to match the thickness of
your paper.
PROBLEM:
Single sheet does not feed properly.
CHECKS:
Set the paper thickness lever to match the thickness of your paper.
Make sure that you are using new, clean sheets of paper and not the creased,
old paper.
Be sure the paper select lever is in the correct position
PROBLEM:
Paper parking does not operate or paper doesn’t advance to the tear-off
position.
CHECKS:
The paper select lever must be set in PIN position (reverse position) to park
the paper.
60
To Next Page
