Tyco DigiTrace 920 Series - Page 82

82
Point Setup Sub-Menu
Parameter Factory User
Tag TAG-(factory ID)
Switch Control Mode Proportional
Prop Band 4°F (2°C)
Deadband
*n/a (5°F(3°C))
Cycle Time *n/a (10 min)
Switch Rating 30.0 A
Circuit Breaker 30.0 A
Max Power 7200 W
3 Ph Pwr Calc No
TS Fail Mode Off
TS CTL Mode TS1-Fail Off
TS 1 Type 100
Ω Plat
TS 1 Lead Resist *n/a (0
Ω)
TS 1 Hi Limit Disable
TS 2 Type 100
Ω Plat
TS 2 Lead Resist *n/a (0
Ω)
TS 2 Hi Limit Disable
Volt Source Pt A (or Pt B)
Fixed Volt *n/a (120V)
Volt Turns Ratio 1.00 to 1
Current Turns Ratio 1.00 to 1
Autocycle Enable
Autocycle Interval 8
Autocycle Units Hours
Override Source Remote
Load Shedding Disable
Common Setup Sub-Menu
Parameter Factory User
Temperature Units °F
Version V3.2x.xx n/a
Ext. Input Not used
Ext. Output Not used
Flash Alarm Output Yes
Alarm Output N.C.
Language English
Point B Used Yes
Passcode 0
Scroll Delay 0.15 secs
Copy Config… (see user manual)