83
This information defines the default 920 Series control module configuration as set by Tyco
Thermal Controls for firmware up to V3.2x. These settings are subject to change without notice.
It is the user’s responsibility to verify that all configuration parameters are chosen appropri-
ately for the intended application.
Communication Setup Sub-Menu
Parameter Factory User
Protocol HTCBUS
HTCBUS Addr (factory ID)
Modbus Addr *n/a (1)
Modbus Sub Addr *n/a (0)
Baud Rate Auto
Parity *n/a (None)
Hardware None, modem, RS-232, RS-485 n/a
Driver Auto
Profile Auto
Tx Delay 0.06 secs
*n/a Parameter may only appear if certain features are enabled. Values shown in brackets are
Tyco Thermal Controls defaults if the settings are enabled.
To Next Page
Loading...
