Tyco MX4428 - Mx4428 Programming Options - Rim800; P0 P1 P2

MX4428 MXP Engineering / Technical Manual Document: LT0273
Device Information and Programming
Page 3-44 24 March 2006 Issue 1.5
3.21.4 MX4428 PROGRAMMING OPTIONS - RIM800
The mode selects the control source for the RIM800 output. By default (mode = 4) the
output follows the logical relay. However if the mode is 0 then the output is controlled by the
corresponding circuit alarm state.
Parameter Description Default
Value Description
0 Controlled by Circuit Alarm
Mode
4 Controlled by Relay
4
P0
P1
P2
P3
P4
P5
P6