under co u n ter extreme
Dispenser
Installation
Dispenser
Installation
6 Place the assembled dispenser into the
drilled hole.
8 Tighten the fixing nut underneath the sink.
(do not overtighten)
7 Insert the second rubber O-ring in the
assembled dispenser located underneath
the sink.
5
Insert one of the provided rubber O-Rings
in the assembled dispenser.
32mm
Drain Pipe
Water OutletPipe
Dispenser Installation
1 First, unscrew the large nut from the bottom of
the dispenser.
2
Press the outflow pipes into the holes of the
dispenser.
※upper hole: water outlet pipe - 152 mm (6 inches)
※lower hole : drain pipe - 102 mm (4 inches)
3
Connect each hose from the dispenser to a
union connector. Connect each hose from
the ionizer to the union connector. When you
connect the hoses, please match the hoses
by color:
i.e., orange‒orange, white‒white
20
21
from Ionizer
from Dispenser
4 Use a 32mm(1
1
/
4
inch) drill bit to drill a hole.
To Next Page
Loading...
