under co u n ter extreme
Ionizer
Installation
Ionizer
Installation
Caution
In the event of a power failure
Remove the power cord from electrical socket and shut off source water
valve.
6 Plug in the power cord and turn on the unit.
※ INTRO Screen appears only when
Initial Power is supplied.
alkaline hose
acid hose
tap water inlet
Ionizer Installation
2
Connect the hoses of the dispenser to the
stem elbows. (when you connect the hoses,
use orange for the acid hose and white for
the alkaline hose)
3 Connect the MCU cable of the dispenser to
the MCU cable on the bottom of the ionizer.
4 Connect the hose from the inflow hole to
the cold water supply at the under-sink
T-Adapter.
5 Make sure all hose connections are firmly
seated in the correct holes, both on the
unit and at the watersupply.
1
Press the stem elbows into the water inflow,
alkali outlet and acidic outlet located on the
bottom of the ionizer.
22
23
To Next Page
Loading...
