Tyent Australia
User’s Manual
MADE IN KOREA
The consumer accepts any and all responsibility
and/or liability if replacement filters and/or parts
are not manufacturer specific.
This product is subject to changes that enhance
its performance without prior notification.
pH Chart
How to Measure : Place 2-3 teaspoons(10-15ml)
of test water in a container and add 2-3 drops of
reagent. Then, mix well and check color of the water
with the pH chart above. (Color is dependent on
water quality and reagent)
The user should be responsible for failure or
improper selection or improper use of the
products such as use in any manner for
which the product was not originally
intended.
To Next Page
Need help?
General
