EasyManua.ls Logo

Tyent UCE-E13T - Ionizer Installation; Customer Serviceable Parts

Default Icon
26 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Under Counter Extreme
22
23
Customer Serviceable Parts
Ionizer Installation
INTRO Screen appears only when Initial
Power is supplied.
Connect the hose from the tap water
inlet to the cold water supply T-adapter.
Connect the Faucet MCU data cable to
the cable connector.
Connect Alkaline Hose and Acidic Hose
to the Nozzle on the top of the water
ionizer body.
Be sure to connect the hose correctly
as indicated on the Nozzle.
Ionizer Installation
Plug in the power cord and turn on the unit.
1st Filter
2nd Filter
Customer Serviceable Parts
Primary Filter: 1st Filter
ATTENTION: If you do not use the TYENT original filter or parts for replacement, it will
cause product malfunction, and it will void your warranty.
The life of the filter can vary greatly due to use, water pressure, water quality and the
changing of the seasons. Filters may need to be replaced sooner than the scheduled time
due to these reasons, and you may notice reduced water quality or declining water taste.
Recommended filter replacement cycle:
(Every 6 months)
Removes harmful chemicals like chlorine,
compounds such as agrichemicals and
detergents, large suspended matters like rust
and sediments as well as other volatile organic
compounds through an efficient activated
absorption method. It also eliminates bad
smells and any remaining dissolved chlorine.
Secondary Filter: 2nd Filter
Recommended filter replacement cycle:
(Every 6 months)
Fine artificial film filters contaminated materials
including ordinary bacteria while maintaining
essential minerals in the water.
*If you do not use TYENT originallters, the following problems will occur:
- Your warranty will be voided.
- It may cause product malfunction.
- The life of the product is shortened.
- It may cause product leakage.
- Filter performance is significantly reduced.
tap water inlet
acidic
hose
alkaline
hose
Connect the hose from the inflow hole to
the cold water supply at the under-sink
T-Adapter. Make sure all hose connections
are firmly seated in the correct holes,
both on the unit and at the water supply.
MCU data cable 연결 cable
connector에 결합되어 있는
보호마개를 제거한다.
Remove

Related product manuals