<Charging>
①
Turn the ignition switch to the
"OFF" position and remove the
battery from the Ride on lawn-
mower.
②
Charge the battery in a well-
ventilated area.
③
Charge the battery with the nor-
mal procedures and avoid quick
charging.
④
Turn the charger switch OFF and
connect the cables to the nega-
tive and positive battery termi-
nals correctly.
⑤
When using a charger, its charg-
ing current should be below 10 A.
T254O531A
Negative (-)
terminal (black)
Positive (+)
terminal (red)
JUMP START
① Turn off all electric devices.
② Connect the positive terminal of
the normal battery to the positive
terminal of the discharged bat-
tery with the jump cable.
③ Connect the negative terminal of
the normal battery to the engine
body of the Ride on lawnmower
for the discharged battery with
the jump cable.
►
T254O532A
④
Firstly, start the engine of the
vehicle with the normal battery.
Then, start the engine of the
Ride on lawnmower with the dis-
charged battery.
⑤
After the engine is started, dis-
connect the negative cable rst.
Then, disconnect the positive
cable.
⑥
Charge the discharged battery
for approx. 30 minutes after the
engine is started.
Make sure to connect the posi-
tive terminal first and connect
the negative terminal to the
engine body of the Ride on
lawnmower with the discharged
battery.
•
WARNING
To Next Page
Loading...
