3. Slide the universal joint back and
forward to make sure the univer-
sal joint is locked securely.
Finally, tug on the universal joint
to make sure it is locked on the
PTO shaft.
•
NOTE
TK0309A
Cutting Height
Control Dial
Hydraulic
Control Lever
TK0310A
Rear Link
L-pin
REAR LINK
1. Set the cutting height control dial
to zero inch position.
►
2. Operate hydraulic control lever
forward to lower the mower rear
links.
Attach the rear link to the mower
with the L-pins.
To Next Page
Loading...
