TK0319A
TK0318A
L
(3) Bolt
L
F R
ADJUSTING FRONT AND REAR
CUTTING HEIGHT
1. Tire pressure must be correct.
2. Make sure the level of the mower
blades is adjusted as shown below.
Then tighten the lock nuts securely.
3. Turn the cutting height control dial
to “2.0” and the anti-scalp roller’s
height to keep clearance between
rollers and ground from 6 to 13 mm
(0.25 to 0.5 in.).
4. Turn right blade by hand parallel to
direction of travel.
►
5. Adjust (L) of front links with lock
nuts so that A is 0 to 5 mm (0 to 0.2
in.) A = (R)-(F).
6. If the difference between front tip
and rear tip of blade is not within
the factory specification, adjust
the length L of front link with bolt
(3). The height of rear blade tip R
should be bigger than the front.
L - MM54 : 530mm ± 5mm
NOTE
TK0317A
Cutting Height
Control Dial
Hydraulic
Control Lever
To Next Page
Loading...
