ENGINE OIL
■ Changing Engine Oil Filter
1. Remove the oil filter using a filter wrench.
2. Smear lightly the rubber seal on the new filter with oil to ensure.
3. Turn the filter clockwise until the seal contacts the base and then turn it another 2/3 turn to tighten it.
Installing New Oil Filter
Apply oil
IMPORTANT
When changing the oil always change the filter.
Always use the same oil, as using different oils or specifications can cause damage.
Dispose off the old oil as per local regulations.
Engine Oil Cap
■ Checking Engine Oil
1. Park tractor on level surface.
2. Check the engine oil when engine is cool enough.
3. Pull out the dipstick, wipe it clean and dip in the oil sump.
4. Ensure that oil level is near the upper mark between the upper and lower mark.
5. If too low, add oil through the oil filler cap, but never excess 100 hours of service interval.
■ Changing Engine Oil
1. Park tractor on level surface, shut-off engine.
2. Open the hood.
3. Remove the drain plug from the bottom of the oil pan and
allow the oil to drain.
4. Replace and install the sump plug.
5. Fill the engine oil to the correct level on the dipstick
6. The grade of oil to be used will depend on the ambient
temperature.
Shipped from factory : 10W/30
Temperature over 25℃ : SAE 30
0 ℃ -25 ℃ : SAE20 or 10W/30, below 0 ℃ : SAE 10W
Dipstick
MAINTENANCE AND SERVICE
5-5
5
To Next Page
Loading...
Need help?
General
