E
MAINTENANCE
E
<Changing>
1. Park tractor on level surface, shut-
off engine.
2. Open the hood.
3. Remove the drain plug from the
bottom of the oil pan and allow the
oil to drain.
4. Replace and install the sump plug.
▶ CHECKING AND CHANGING ENGINE OIL▶ CLEANING RADIATOR
When working in a grassy field or
working at night, the radiator or
condenser grille may be clogged by
grass, straws or bugs, reducing cooling
performance.
In this case, pull the radiator grill up and
clean it with low pressure air or clean
water.
If dust is stuck between the fan and tube,
flush the area with clean water.
7
Do not clean the radiator fin with water
jet.
It can deform the fin.
IMPORTANT
RADIATOR GRILL
<Inspection>
1. Park tractor on level surface.
2. Check t
he engine oil when engine is
cool enough.
3. Pull out the dipstick, wipe it clean
and dip in the oil sump.
4. Ensure that oil level is near the
upper mark between the upper and
lower mark.
5. If too low, add oil through the oil
filler cap, but never excess 100
hours of service interval.
DIP STICK
ENGINE OIL
DRAIN PLUG
ENGINE OIL CAP
To Next Page
Loading...
