MAINTENANCE
E
12
▶ FUEL TANK
Use clean diesel fuel only.
<Checking and refueling>
1. Turn the key switch ON.
2. Check the fuel level with the fuel
gauge on instrument panel.
3. If fuel is near to empty, the empty
warning lamp turns on.
4. Fill the fuel tank, if too low.
5. It i
s a good practice to refill the tank
immediately after use to avoid
condensation.
<Cleaning the element>
1. Open the hood.
2. Remove t
he element by unlocking
the clamp.
3. Remove dust by blowing it out of
the element with compressed air.
4. Check the element to ensure it is
not damaged.
5. Reassemble t
he element.
※ Replace the element after cleaning it
5
times or it is damaged.
CLAMP
Never beat the element on a stone or
concrete floor/wall to clean it
Check all connections and hoses
especially on the clean side of the air
cleaner to ensure no dusty air can enter
the engine.
Check the element for flaws by putting a
light inside the element.
When reassembling make sure all
surfaces seal correctly to keep dust out.
When working in dusty conditions
increase the service frequency.
IMPORTANT
FUEL TANK
As diesel fuel equipment is susceptible
to contamination by dust or water,
ensure that all dust and water is kept
well away from the fuel tank.
IMPORTANT
To Next Page
Loading...
