TYM T700 - Stopping the Engine and Warming Up

SELF CHECK FUNCTION AND OPERATION
1) Raise SOL
1-1) Put the self check dial to raise SOL position.
1-2) Insert the ignition key and turn in ON position
1
3) If
it
beeps Control with upper limit knob till it doesn
’
t sound
1
-
3)
If
it
beeps
,
Control
with
upper
limit
knob
till
it
doesn t
sound
.
1-4) Push the external hitch switch in ON position
1-5) Push the manual switch to raise position
1-6) Raising the implement with beep sound is normal
1-7) A stationary implement with a beep sound is not normal.
Check Solenoid valve.
2) Lower SOL
2-1) Put the self check dial to Lower SOL position.
2-2) Insert the ignition key and turn in ON position
2-3) If it beeps, Control it with the upper limit knob till it doesn’t
sound.
2-4) Push the external hitch switch in ON position.
2-5) Raise the Hitch(Implement) to maximum height.
2-6) Push the manual switch to Lower position.
2-7) Lowering the implement with a beep sound is normal
2-8) Stationary the implement with beep sound is not normal ,
check Solenoid valve.
2-9) If there is no beep sound, Controller raise signal or Solenoid
valve is abnormal.
3) Reverse control sensor
3-1) Put the self check dial to reverse sensor position.
3-2) Push the reverse control switch in ON position
3
3) Put the reverse lever to reverse position
3
-
3)
Put
the
reverse
lever
to
reverse
position
.
3-4) Beep sound is normal.
3-5) Reverse control sensor is not normal if beep sound
does not operate. Check Reverse control switch
53