TYM T700 - Tractor Braking and Steering; Tight Turns in the Field; Normal Braking and Parking

4) Turn control switch
4-1) Put the self check dial to turn control position.
4-2) Insert the ignition key and turn in ON position.
4-3) Control with Position control knob till the beep
sound doesn’t sound.
4-4) Push the turn control switch in ON position.
4-5) Turn the steering wheel to right hand side.
4-6) Beep sound turning to RHS is normal.
4-7) Turn the steering wheel to center.
4-8) Turn the steering wheel to left hand side.
4-9) Beep sound turning to LHS is normal.
4-10) Turn the steering wheel to center
If it does not beep while turning to LH or RH, Check the
Turn control sensor
5) Position control
5-1) Put the self check dial to position control position.
5-2) Turn the upper limit switch counter clockwise.
5
3) Beep sound is normal
5
-
3)
Beep
sound
is
normal
.
5-4) Turn the upper limit switch clockwise.
5-5) Beep sound is normal.
5-6) position control is not normal if beep sound does not
operate.
Check the position control Dial or adjust the sensor
54