Please note that the following conditions are normal in product use.
---IF THE SENSOR IS NOT IN THE NORMAL OPERATION---
11.1 The data updating time of the sensor is about 5 minutes. And if you change the
sensor to another wheel, the previous data may stay for a while. If the sensor is removed,
there will still be data staying on the monitor. It is normal, and it may take up to 2 hours for
the monitor to completely disappear after hours of data displayed.
11.2 There will be a slight air leak in the tire after the sensor is installed. It is normal.
Please rest assured to use it.
11.3 It is normal for the sensor to be worn and corroded by the external environment. We
recommend that you buy extra sensors as backup. When the sensor is abnormal, you can
try to solve the problem according to the following instructions. If the problem persists, you
can contact us for after-sales service to get the replacement sensor.
It is recommended to test the sensor first. You could take off the sensor from your tire to
see if the machine alarms.
1. If the monitor begins beeping, it means your sensor is in normal operation. Then you
could try to re-install the sensor. If it still does not work, maybe the sensor lacks battery
power. Then you could try another battery again. And here I would like to provide a
change-battery video to help you. The video link is as follows: https://youtu.be/JXc0sV
-
jN19Y
2. If it does not alarm, it may also mean that the sensor lacks battery power. You could try
another new battery again. The battery-change video is mentioned above, and you could
refer to it.
11.4 It is normal for the tire pressure monitor to measure the tire pressure with a certain
degree of accuracy (when you find that its measurement result is different from your tire
pressure gauge).
11. Some Using Tips
To Next Page
Loading...