EasyManua.ls Logo

typical GC0303D - Adjusting Thread Tension; Adjusting Presser Foot and Walking Foot Pressure

typical GC0303D
38 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
-8-
14
15
2
5
1
3
4
16. Adjusting the thread tension (Fig.14)
1
2
Needle thread
Bobbin thread
●Stitch seam when needle thread tension is too weak
●increase the needle thread tension
●decrease the bobbin thread tension
●Stitch seam when needle thread tension is too strong
●decrease the needle thread tension
●increase the bobbin thread tension
Bobbin thread
Decrease
increase
Increase
decrease
Normal stitch
17. Adjusting the presser foot pressure
(Fig.15)
Decrease
Increase
Decrease
Increase
<Bobbin thread tension>
Adjust by turning the screw ① until the bobbin case
drops gently by its own weight while the thread end
coming out of the bobbin case is held.
<Needle thread tension>
After adjust the bobbin thread tension, adjust the
needle thread tension so that a good, even stitch
seam is obtained.
1.Lower the presser foot;
2.Adjust by turning the thread tension nut ②.
<Adjusting the presser foot pressure>
1.Loosen the lock nut ①;
2.Turn the adjusting screw ② to adjust the
pressure of presser foot, if it's not enough,
please turn the screw ⑤ to increase the
pressure.
*The pressure should be as week as possible,
but strong enough so that the material doesn't
slip.
3. Tighten the nut ①.
<Adjusting the walking foot presser>
4. Loosen the nut ③;
5. Turn the screw ④ clockwise to increase the
pressure, on the contrary, turn the screw ④
counterclockwise to decrease the pressure;
6. Tighten the nut ③.
typical GC0303D - Adjusting Thread Tension; Adjusting Presser Foot and Walking Foot Pressure